Phone: 07517 675415 or 01233 630366
Email: info@e-fms.co.uk
Connect With Us:
Please share this page:
MACHINERY FOR SALE
Turbovac
Showing 1–12 of 15 results
-
Turbovac D10 Vacuum Packer
The Turbovac D10 vacuum packer is made from high grade stainless steel, the D10 vacuum packer is a great choice for your vacuum packing requirements. The D10 vacuum packing machine has a swing over lid that is balanced on lid springs to enable the operator to move the lid across with very little effort. The advantage of using a double chambered vacuum packer over a single chambered one is that the operator can be preparing the next lot of products and positioning them correctly in the chamber whilst the vacuum packer is vacuum packing more products in the other chamber. This speeds up the vacuum packing process considerably. The control panel for the D10 vacuum packer is fully digitally controlled, featuring a sensor control that is accurate to 1Mbar and continues to pull a vacuum until the set amount is reached. This sensor control can reduce vacuum packing time and enables the operator to create the same amount of vacuum for every product they pack. The D10 vacuum packer comes with four seal beams, two in each chamber, which are positioned to the front and rear of the chamber. They are 620mm in length and the distance between the two is 520mm. Each seal beam creates a double seal on the vacuum bag, however the machine can be upgraded so that cut off wire can be used to replace one of the seal elements and the two different wires are controlled independently from the control panel. The vacuum packer can be easily cleaned, maintained and serviced. The control panel features something called 'service management' and this tells the operator when the vacuum packer requires a service. All the electrical parts of the vacuum packing machine are covered by IP65 water and dust level protection. The vacuum packer is also fitted with a world renown Busch vacuum pump, Busch coat all the internal components of the vacuum pump to further improve their life.The pump fitted as standard is 100m3 but you do have the option of a 160m3 pump if you would like the vacuum packer to complete its cycle a bit quicker. -
Turbovac D30 Vacuum Packer
The Turbovac D30 vacuum packer is constructed from stainless steel with a stainless steel chamber. The vacuum packer's electrical parts are all covered by IP65 water and dust level protection and the chambers are easily cleaned after use. The vacuum packer has a digital control panel that can store up to 10 different programmes. Each programme can be set with individual settings for the packaging of different types of product, this reduces the amount of down time needed when changing over from one product to another. The control panel of the vacuum packer comes with sensor control which allows the operator to set the exact amount of vacuum they would like to achieve which each product and it is accurate to within 1mBar of vacuum pressure.The digital control panel also tell the operator when the vacuum packing machine requires a service. The D30 vacuum packer comes with four seal beams all of 820mm in length with a distance of 700mm between each pair. There are two seal beams in each vacuum packer chamber and they create a double seal imprint on the vacuum bag /pouch. The D30 vacuum packer can be fitted with seal and cut off at an extra cost, with each wire being controlled separately by the digital control panel. There are various different vacuum packers available in the D-range so if you think this machine is not suitable for your needs take a look at the D60, D10 and D40 vacuum packers. -
Turbovac D40 Vacuum Packer
The Turbovac D40 floor standing double chamber vacuum packer is the biggest vac packer in the Turbovac range. The vac packer runs of a 3ph electric supply and comes as standard with 10-programmable control panel, allowing customer to have different programmes for different products. The D40 vacuum packer has sensor control, which means that every product no matter how big or small is vacuum packer to the same level of vacuum. The D40 vac packer comes with a choice of vacuum pumps, the Busch 160m3 pump and the Busch 300m3 pump. The bigger the pump the quicker the cycle time. So if cycle time of an extra 15 seconds is not a problem then the Busch 160m3 pump is the way to go, saving you money. The Turbovac D40 vacuum packer can be fitted with gas flush to further prolong shelf life and this couple with the sensor control can produce 'pillow packs' leaving excess air inside the pack for products that would otherwise be crushed by a standard vacuum. for customer wanted to vacuum pack lots of smaller packs in one go, the Turbovac D40 now has the option of four sealbeams in the chamber, in the shape of a square. For more information on this model please click here. -
Turbovac D60 vacuum packer
The Turbovac D60 vacuum packer comes with sensor control as standard allowing for a more exact vacuum each and every time you use the vacuum packer. The vac packer comes in either a 1ph or 3ph electric supply and each chamber has two seal beams of 600mm in length situated and the front and the back for the chamber. The machine is built from stainless steel and has a painted aluminium chamber. All Turbovac vacuum packers are built using the world re-known Busch vacuum pump, giving you peace of mind that what is driving the machine is Busch's technology and expertise in the vacuum packer industry. -
Turbovac M20 Floorstanding Vacuum Packer
The Turbovac M20 vacuum packer features a transparent acrylic lid for increased visual control over your packs, particularly useful when packing moist or liquid products. The M20 vacuum packer is made from high quality stainless steel and is extremely easy to clean for sanitisation purposes. The vacuum packer comes with Turbovac's new control panel which can store up to 10 different programmes and sensor control, which actually measures the amount of vacuum in the chamber. The new control panel of the vacuum packer also measures the moisture evaporation when packing liquids etc. At the optimal level and before the product starts loosing moisture, the sensor detects this point and continues the cycle by sealing the package. The M20 vacuum packer has two seal beams one the left and one on the right of the chamber, each measure 520mm in length and are positioned 545mm apart. Each seal beam has two lines of sealing wire to create a double seal on the vacuum packer bag. The vacuum packer also comes with soft air, which is used when packing products with sharp edges, such as meat with bones in. The products notoriously burst bags when vacuum packers release the air back into their chambers and the vacuum packer bags are deflated quickly around the product. The soft air option regulates the release of the air back into the chamber, meaning the vacuum packer bag deflates slowly around the product, minimising burst bags. -
Turbovac M40 Floorstanding Vacuum Packer
The Turbovac M40 vacuum packer is floor standing and constructed completely from stainless steel. The vacuum packer has two seal beams which are 520mm long, they produce a double seal on the vacuum bag and are positioned either side of the vacuum chamber. The distance between the two seal beams is 545mm and can be quickly and easily converted to seal and cut off simply by changing one of the wires on the seal beam. Servicing the vacuum packer couldn't be easier, the digital panel has a self diagnostic control that identifies service needs and possible operational errors. The M-range of vacuum packers save on packing time because of their full sensor controls and computer assisted vacuum process. The best possible shelf life is also achieved due to the vacuum packers sensor control being accurate to within 1Mbar, enabling the machine to pull the same amount of vacuum on every product, no matter how big or small. All the electric components of the vacuum packing machine are covered by IP65 dust and water level protection levels, protecting all electronic parts from splash water and dust. The M40 vacuum packing machine comes complete with either a single phase or three phase Busch 063m3 vacuum pump. Busch pumps are world renown and coat their internal components to extend the life of the vacuum pump. -
Turbovac M60 Floorstanding Vacuum Packer
The Turbovac M60 vacuum packer is the largest single chamber vacuum packer in the Turbovac range. With large seal beam configurations available the vac packer comes as standard with one long seal beam running along the front of the vac packer and a smaller seal beam running along the right side of the vac packer. Both seal beams are double seal for increased bag security from leakage, and the option to add an extra one or two seal beams is possible at an additional charge. The M60 vacuum packer is fitted with the world re-known Busch vacuum pumps and runs off a 3ph electric supply. The lid is made entirely from stainless steel with a flat bed to place the product on whilst vac packing. The machine is made to work in factories running 8 hour shifts, and is easily cleaned and maintained. -
Turbovac M70 Floorstanding Vacuum Packer
The Turbovac M70 vacuum packer is floor standing and is constructed from stainless steel with a coated aluminium chamber. These vacuum packers are extremely reliable and competitively priced on both the initial purchase and the required on going servicing and maintenance. The aluminium range of vacuum packing machines has proved to be one of the most popular range of vacuum packers on the market. The M70 vacuum packing machine comes with a digital display which can loaded with up to 10 different programs to suit different product types and different bag thickness. The new Turbovac control panel comes as standard with sensor control, meaning that each pack that is produced has the same level of vacuum regardless of the size of the package. The M70 vacuum packer has various options available, starting with the electric supply. The vacuum packer comes as standard with a Busch 063m3 vacuum pump running of a 3 phase supply, however this can be changed to the equivalent 1 phase vacuum pump for an extra cost. The vacuum packer has two double-seal seal beams, one on the left and one on the right hand side of the machine which are of 500mm in length. The distance between the two seal beams is 500mm. The vacuum packer can also be fitted with a gas flush option which enables the vacuum bag to be flushed with a different combination of gases to help prolong the life of the food packed within. This is often used for products that would normally be crushed upon vacuum and instead of pulling the bag around the product and crushing it, the gas is flushed into the bag creating a sealed bag with a product surrounded by the gas chosen. -
Turbovac M80 Floorstanding Vacuum Packer
The Turbovac M80 vacuum packer is made from high quality stainless steel with a painted aluminium chamber. The lid has a small window in it to help with visibility when packing. The M80 vacuum packer comes as standard with two seal beams, one running along the front of the machine which is 770mm in length and one running along the right hand side of the vacuum chamber which is 500mm in length.Other seal beam configurations are available, please call for more information. The vacuum packer is floor standing and comes with a choice of 1ph or 3ph electric supply. The M80 vacuum packer like the other models in Turbovac's M-range of vac packers comes with a new digital display control panel. This allows the M80 vacuum packer to now come as standard with sensor control. Sensor control in a vacuum packer is a great way to ensure each and every pack that is done in the vacuum packer comes out with the same level of vacuum. This new control panel can store up to 10 different programmes and can also measure moisture levels so that at the optimal moisture point (the point at which moisture starts to leave the product itself) the vacuum packer switches to seal and the minimal amount of moisture is lost from the product being packed. This is extremely beneficial when vacuum packing moist products or liquids. The M80 vacuum packer is one of best selling floor standing vacuum packers, built to be hard wearing, easy to use and great value for money. If you think this machine might be a little too big for your purpose then please take a look at the M70 vacuum packer, all the same benefits but just a bit smaller in size. -
TURBOVAC SB-52O VACUUM PACKER
Turbovac is one of the leading brands for vacuum packaging machines in the world. Turbovac, based in Holland, combines more than 50 years of experience with craftsmanship and new advanced technologies to ensure you that all Turbovac machines are innovative with a high quality standard. Turbovac machines are designed for high reliability and low-cost maintenance. Turbovac Basic machines have an extremely attractive price-quality ratio. All Basic machines are equipped with a special coated aluminium chamber and lid for easy cleaning and therefore ideal for the food industry. -
Turbovac T20 Tabletop Vacuum Packer
The Turbovac T20 vacuum packer is the smallest vacuum packer in the Turbovac range. The vacuum packer is constructed from stainless steel and has a stainless steel chamber. The Turbovac vacuum packer has a control panel that holds one program and the vacuum time and seal times can be set individually on the vacuum packer with the digital time controller to suit the customers product and bag types. The T20 vacuum packer comes with a single seal beam which is 280mm in length and a manual that explains in detail how to service and maintain the vacuum packer and vacuum pump.The distance from the vacuum packers seal beam to the back of the vacuum packer's chamber is 310mm. The vacuum packer completes its vacuum packing cycle in approx 30-45 seconds dependent on product being vacuum packed and runs off a standard single phase 3-pin plug. With dimensions of just 365 x 500 x 340mm this vacuum packer is ideal for the customer who has little space. It is a vacuum packer designed for occasional use. -
Turbovac T40 Tabletop Vacuum Packer
The Turbovac T40 vacuum packer comes with a choice of Busch vacuum pump, 016 or 021m3. The 016m3 vacuum pump is the perfect choice for restaurants and smaller butchers shops where the vacuum packer is not used that frequently. The 021m3 vacuum pump is for more frequent use of the vacuum packer. The T40 vacuum packing machine comes complete with a seal beam capable of sealing a bag of 420mm in width and the distance from the seal beam to the back of the chamber is 370mm. It creates a double seal on the bag and can be easily converted to seal and cut off just by changing the wire type. The vacuum packer is constructed in stainless steel and has no wires in the chamber to improve cleanliness and reliability. The vacuum packing machines lid features a floating hinge system which prevents damage to the lid if anything is caught between the lid and the chamber. The Turbovac vacuum packer has digital controls where the vacuum time and seal time can be individually adjusted to suit different products and bag types and has a warm up button to get the machine and vacuum pump up to temperature before vacuum packing commences. Vacuum packing couldn't be simpler, place the product in a vacuum bag or pouch place into the chamber overlapping the seal beam and close the lid. When the vacuum packer lid closes the vacuum cycles starts ans when it is complete the lid opens automatically.
Please share this page
Elite Food Machinery Limited,
Unit 7 Chunnel Industrial Estate,
Victoria Crescent, Ashford,
Kent TN23 7HL
Email: info@e-fms.co.uk
Phone: 01233 630366
Mobile: 07517 675415
Company Information
Company Number: 9847799, Registered Address: 39 High St, Battle, East Sussex TN33 0EE
VAT Registration Number: 232 6447 18
Expertise
We also have experience with Audionvac, Henkelman, Turbovac, Multivac, Webomatic, Surevac, Samic, and Tepro Vacuum Packing Machines
© 2026 Elite Food Machinery Services